How do you change a tire and how do you change the oil in a vehicle?

Step by step instructions for both


please %26amp; thanks.How do you change a tire and how do you change the oil in a vehicle?
to change a tire.





#1 put transmission in park ( auto) or 1st (standard)


#2 set parking brake.


#3 before u jack the car up. take the tire tool and loosen the lug nuts a little.


#4 jack the car at the factoiry approved jack points (thele be in the owners manuel)


#5 now remove the lug nuts at and lift the tire off.


#6 now take the spare and put it on the wheel


#7now pul all of the lug nuts on finger tight.


#8 now tighten all of the lugnuts in sort of a star pattern(don't put the nut as tight as u can, just kind of tight and move on to the next one .)


#9now put the hub cap back on if u have one


#10 now lower the car and put the tire tool, jack , and flat tire away.


#11 before u go, make sure the lug nuts are as tight as u can get them.





how to change oil.





#1 put the transmission in park(auto) or 1st(stick)


#2 apply the parking brake


#3 block the wheels


#4 jack the car up ( not on the same jack u use for tire changing ,its to flimsy, go buy a good one (and a jack stand)


#5 put a tub under the pan under the oil pan and and take the drain plug out( carful, the oil can be hot)


#6 once the oil has all drained out put the plug back in.


#7 get an oil filter wrench. and take the filter off. ( u dont have a filter wrench, than take a screwdriver and stick it into the filter.( carful of hot oil)


#8 take the new filter and put a bit of oil around the top ( for a good seal) and screw it in place by hand.


#9 go under the hood, and put the new oil in through the fill cap the owners manuel will tel u the correct amount.( let the oil bottles drain at least a minute each. pull the dipsick and check that the oil is at the correct level.


#10 start the engine and check for leaks











hope i helped (;How do you change a tire and how do you change the oil in a vehicle?
tire: loosen the nuts with the wrench that the car brings, lift the car with the jack the car brings, then take the nuts completely off, remove the wheel and put the spare and nuts back on... tighten before lowering and then tighten harder after tire n the ground...





oil i reccomend you take somewhere, its alot of work...


if you still wanna do it, under the engine pan there is a screw you remove and the old oil falls out (in a container you will put below, put the screw back on and change the oil filter, then put the ammount of oil required for your car through the oil cap on top of the cylinder head...
Have a friend show you. It would be easier than trying to post a complete answer here. The person who decided to write a novel for an answer missed a few steps and made some bad suggestions. As I said...you need to have a friend actually show you the proper method. If you go by the other person's ';instructions'; you will get hurt and possibly do damage to your car.